Enclosure Show Slot; Syntax; Parameters - Adaptec RAID 2120S Software Reference Manual

enclosure show slot

To display the status of a specific device slot on a specific SAF-TE
enclosure management device, use the enclosure show slot
command. You can also use this command to display the status of
all device slots on the enclosure management device or devices.

Syntax

enclosure show slot [{enclosure}] [{slot}]

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device for which you want to display device slot status
information. For this version, the controller supports a
maximum of eight enclosure management devices on each
bus.
If you do not specify an ID, the command displays the device
slot status for all enclosure management devices connected to
the controller.
{slot}
Specifies the unit number associated with the device slot
whose status you want to display. This integer can range from
0 to 15 inclusive. Typically, the slot unit number is limited by
the physical number of device slots in the enclosure
management device.
If you do not specify a unit number, the command displays the
status for all device slots on the enclosure management device
or devices.
enclosure Commands
11-33