Reset; Save - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide
Controller #0 (03:05:00)

RESET

The RESET command resets a controller to its initial start-up
state and waits for the controller's on-board kernel to restart. If
the controller's flash components were updated, the new
firmware is executed.
Use the /C switch to reset a specific controller or multiple
controllers.
You must reset your system or issue a RESET command
following an UPDATE or a SAVE command because these
commands effectively shut down the controller's kernel.
Default Switch Values
If you do not include the /C switch, the AFU returns a fatal
error message.
Examples
A:\> AFU RESET /C 0
Resets controller 0.
A:\> AFU RESET /C ALL
Resets all supported controllers.

SAVE

The SAVE command saves the contents of a controller's flash in
a UFI file. The name of the UFI file is based on the controller
type and cannot be changed. Use the /D switch to specify the
drive and directory where you want AFU to create the UFI file.
Note that you cannot specify more than one controller with the
SAVE command. If you include the /C switch and specify more
than one controller ID, the AFU displays an error message and
exits.
You must reset your system or issue a RESET command
following a SAVE command because this command effectively
shuts down the controller's kernel.
12-10
Adaptec 2200S