Examples; Related Information - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

Examples

Before renumbering an array, use the container list command
to obtain information about any existing arrays. As the following
example shows, there is an array 0 (a volume set) on this controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 20.0MB
The following example renumbers array 0 to array 5:
AAC0>container move 0 5
Executing: container move 0 5
Use the container list command after using the container
move command to display information about the array you just
renumbered, as in the following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 5 Volume 20.0MB
As a result of renumbering array 0 to array 5 with the container
move command, the Num Label column displays ID number 5
instead of 0. This column also displays the label assigned to the
array when the array was created. If no label was assigned to the
array then no label appears in the column.

Related Information

container commands:
■
container list
5-68
Scsi Partition
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
0:03:0 64.0KB:
Scsi Partition
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
0:03:0 64.0KB:
(page 5-54)
10.0MB
10.0MB
10.0MB
10.0MB