Enclosure Commands; Enclosure Activate Slot; Syntax; Parameters - Adaptec RAID 2120S Software Reference Manual

enclosure activate slot

To activate a device in a specified slot of the specified SAF-TE
enclosure management device, use the enclosure activate
slot command. Specifically, this command makes the device that
resides in the slot available on the SCSI channel.

Syntax

enclosure activate slot {enclosure} {slot}

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to activate a device. For this version,
the controller supports a maximum of eight enclosure
management devices on each bus.
{slot}
Specifies the unit number associated with the slot. This is the
slot that contains the device you want to activate. This unit
number can range from 0 to 15 inclusive. Typically, the slot
unit number is limited by the physical number of device slots
in the enclosure management device.

Examples

Before activating a device, you might want to use the enclosure
show slot command to determine the current device state.
As the following example shows, the current device state setting is
NOTACTIVATE:
AAC0>enclosure show slot 0
Executing: enclosure show slot 0
Enclosure Slot scsiId Insert
--------- ---- ------ -------
0 0 0:00:0
0 1 0:01:0
0 2 0:10:0
0 3 0:03:0
0 4 0:04:0
1 0 1:00:0
1 1 1:01:0
1 2 1:10:0
Status
-----------------------------
4 OK UNCONFIG NOTACTIVATE
0 OK UNCONFIG ACTIVATE
0 OK UNCONFIG ACTIVATE
0 OK UNCONFIG ACTIVATE
0 OK UNCONFIG ACTIVATE
0 OK CONFIG ACTIVATE
0 OK UNCONFIG ACTIVATE
0 OK UNCONFIG ACTIVATE

enclosure Commands

11-3