Container Scrub; Syntax; Parameters; Switches - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

container scrub

To scrub a redundant array, use the container scrub command.
A mirror set, a multilevel array of mirror sets, and a RAID-5 set are
examples of redundant arrays. For a mirror set or a multilevel array
of mirror sets, this means the command reconstructs the data on
both mirror halves (partitions), if found to be different. For RAID-5
sets, the command recalculates and replaces, if necessary, the parity
information.

Syntax

container scrub [/io_delay{=integer}] [/
no_repair{=boolean}][/wait{=boolean}] {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the redundant array to
scrub.

Switches

/io_delay{=integer}
Specifies the number of milliseconds the controller waits
between the I/O operations required to scrub the redundant
array. The I/O delay value is not preserved between reboots of
the operating system. Valid values are 0 through 100.
/no_repair{=boolean}
Specifies whether the command performs the scrub operation
on the redundant array without repairing the error. If you set
this switch to TRUE, the command performs the scrub action
without repairing the error. If you set this switch to FALSE, the
command performs the scrub action and repairs any errors.
5-94