Container Show Cache; Syntax; Parameters; Examples - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

container show cache

To display the current cache parameters associated with a specific
array, use the container show cache command. Typically, you
use this command after setting cache parameters for a specific array
using the container set cache command.

Syntax

container show cache {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the array whose associated
cache parameters you want to display.

Examples

Before setting cache parameters for a specific array, use the
container list command to obtain information about any
existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller with no file system on it (as evidenced by None
displayed in the Usage column). Assume the cache parameters for
this array were previously set with the
command:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Volume 15.0MB
5-110
container set cache
Scsi Partition
Usage C:ID:L Offset:Size
None 0:02:0 64.0KB: 15.0MB