Disk Show Partition; Syntax; Examples - Adaptec RAID 2120S Software Reference Manual

disk show partition

To display a list of partitions on the disks attached to the currently
opened controller, use the disk show partition command.

Syntax

disk show partition

Examples

The following example shows a sample output from the disk show
partition command:
AAC0>disk show partition
Executing: disk show partition
Scsi Partition Array
C:ID:L Offset:Size Num Type
------ ------------- --- ------ --- ------ ---
0:02:0 64.0KB:20.0MB 0
The following sections provide more information on the columns
that the disk show partition details command displays.
The SCSI C:ID:L Columns
The C:ID:L column displays the SCSI channel number, the SCSI
device ID, and the SCSI device logical unit number for each disk on
the currently opened controller.
In the example, the command displays the SCSI channel number,
the SCSI device ID, and the SCSI device logical unit number for one
disk (0:02:0) on the currently opened controller.
The Partition Offset:Size Column
The Partition Offset:Size column displays the offset (in bytes) into
the SCSI device and the size of the partition (in bytes). In the
example, the offset is 64.0 KB and the size is 20.0 MB.
If a partition is dead, the ":" (colon) in the Partition Offset:Size
column changes to a "!" (exclamation point). See the disk remove
(page
dead_partitions
dead partitions.
MultiLevel
Num Type R/W
Volume 0 None RW
7-9) command for more information on
disk Commands
7-19