Diagnostic Moderation Set Timer; Syntax; Parameters; Related Information - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

diagnostic moderation set timer

To set the default interrupt timer on the controller, use the
diagnostic moderation set timer command.
Caution:
Use this command only under the direction of
!
technical support.

Syntax

diagnostic moderation set timer {integer}

Parameters

{integer}
Specifies the value (for example, 10) you want to set as the
default interrupt timer on the controller. The interrupt timer is
the delay time in 100 microsecond units before the controller
issues an interrupt to the host computer. For example if the
interrupt timer is set to 10, the controller batches I/O request
responses for one millisecond and issues an interrupt to the
host computer.
The default interrupt timer is 0 (zero).

Related Information

diagnostic commands:
■
diagnostic moderation set count
■
diagnostic moderation show count
■
diagnostic moderation show timer
8-8
(page 8-7)
(page 8-9)
(page 8-10)