Enclosure Set Power; Syntax; Parameters; Switches - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

enclosure set power

To turn the power of a specific power supply on a specific SAF-TE
enclosure management device on or off, use the enclosure set
power command. Typically, most enclosure management devices
turn on their associated power supplies by default after power up.

Syntax

enclosure set power [/off{=boolean}] {enclosure}
{powersupply}

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to turn the power of a specific
power supply on or off. For this version, the controller
supports a maximum of eight enclosure management devices
on each bus.
{powersupply}
Specifies the unit number associated with the power supply
whose power you want to turn on or off. The unit number for
the power supply can range from 0 to 15 inclusive.

Switches

/off{=boolean}
Specifies whether to turn the power supply associated with the
specified unit number on or off. If you set this switch to TRUE,
the command turns off the power supply associated with the
specified unit number. If you specify FALSE, the command
turns on the power supply associated with the specified unit
number.
This switch defaults to FALSE, which means the command
turns on the power supply if you do not specify the switch.

Examples

Before turning a power supply on or off, you might want to use the
enclosure show power command to determine the current
setting for the power supply or supplies. As the following example
11-20