Examples - Adaptec RAID 2120S Software Reference Manual

{container}...
Specifies the ID number (0 to 63) of the array or arrays to add
to the previously specified multilevel volume set. The previous
file system information applies to these additional arrays as
well.

Examples

Before extending a multilevel volume set, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a multilevel
volume set) on this controller. In addition, the example shows array
1 and array 2 (both volume sets created with the container
create volume command).
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10MB
63 Volume 10MB
1 Volume 15MB
2 Volume 15MB
The following example extends a multilevel volume set (array 0) by
adding arrays 1 and 2 (which are both volume sets):
AAC0>container extend mvolume 0 1 2
Executing: container extend mvolume 0 1 2
container 0 extended
As the command executes, note that the title bar of the DOS window
displays the status of the command. For example:
Stat:OK!Task:102,Func:FSX Ctr:0,State:RUN 84.3%
See page 3-10 for detailed information on the status information that
the command displays in the title bar as it executes the task.
Use the container list command after using the container
extend mvolume command to display information about the
container Commands
Scsi Partition
Usage C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
None 0:03:0 64.0KB:
None 0:04:0 64.0KB:
10.0MB
15.0MB
15.0MB
5-47