Task Suspend; Syntax; Parameters; Switches - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

task suspend

To suspend one or all tasks running on the currently opened
controller, use the task suspend command.

Syntax

task suspend [/all{=boolean}]

Parameters

{integer}
Specifies the task ID for the task to suspend. Perform a task
list /all to display the task IDs for all tasks currently
running on the open controller before suspending a specific
task or all tasks.

Switches

/all{=boolean}
Specifies whether to suspend all running tasks. If you set this
switch to TRUE, the command suspends all tasks that were
running on the currently opened controller.
If you do not specify this switch or a valid task ID, the
command displays an appropriate error message.

Examples

Before suspending a running task, use the task list command to
identify any currently running tasks, as in the following example:
AAC0>task list
Executing: task list
TaskId Function Done% Array
------ -------- ----- ---------
101 Scrub 24.6%
The following example shows the use of the task suspend
command to suspend task 101:
AAC0> task suspend 101
Executing: task suspend 101
10-12
State Specific1
----- ---------
0 RUN 00000000
Specific2
---------
00000000