Container Remove File_System; Command Availability; Syntax; Parameters - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

container remove file_system

To remove the file system from an array, use the container
remove file_system command. Use this command when the file
system on the array is no longer needed.
This command fails if there are open files on the array.

Command Availability

This command and its associated switches (if any) are supported on
the following operating systems:
■
Windows NT
■ Windows 2000 (basic disk only)
■ Windows XP (basic disk only)

Syntax

container remove file_system {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the array from which you
want to remove the file system.

Examples

Before removing a file system from an array, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB
5-88
Scsi Partition
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB: 10.0MB