Syntax - Adaptec RAID 2120S Software Reference Manual

diagnostic Commands
In this Chapter
diagnostic clear boot_parameters
diagnostic dump structures
diagnostic dump text
diagnostic load_arrays
diagnostic moderation set count
diagnostic moderation set timer
diagnostic moderation show count
diagnostic moderation show timer
diagnostic set boot_parameter
diagnostic show boot_parameter
diagnostic show history
The diagnostic commands are used to help fix problems that can
occur during controller operation. The diagnostic commands
should be used only under the direction of technical support.
Use the following syntax for diagnostic commands:
diagnostic command [/switch{=value}] [parameter]
8
8-2
8-3
8-4
8-6
8-7
8-8
8-9
8-10
8-11
8-12
8-13
8-1