Diagnostic Moderation Set Count; Syntax; Parameters; Related Information - Adaptec RAID 2120S Software Reference Manual

diagnostic moderation set count

To set the default interrupt count on the controller, use the
diagnostic moderation set count command.
Caution:
Use this command only under the direction of
!
technical support.

Syntax

diagnostic moderation set count {integer}

Parameters

{integer}
Specifies the value (for example, 700) you want to set as the
default interrupt count on the controller. The interrupt count is
the number of outstanding requests on the controller needed
before the delay time (the time specified by the diagnostic
set timer command) takes effect. For example, if the
interrupt count is set to 32 and the delay time is set to 10, the
controller batches I/O request responses for one millisecond
only if there are more than 32 I/Os outstanding in the one
millisecond interval.

Related Information

diagnostic commands:
■
diagnostic moderation set timer
■
diagnostic moderation show count
■
diagnostic moderation show timer
diagnostic Commands
(page 8-8)
(page 8-9)
(page 8-10)
8-7