Container Readonly; Syntax; Parameters; Examples - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

container readonly

To change an array's read-write status to read-only status, use the
container readonly command. Subsequent modifications to
the data on the array are prohibited. To use the container
readonly command, the array cannot be in use by any application.

Syntax

container readonly {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the array to make read-
only.

Examples

Before making an array read-only, use the container list
command (with the /full switch) to obtain information about any
existing arrays. As the following example shows, there is an array 0
(a volume set) on this controller. Note that the RO column is blank:
AAC0>container list /full
Executing: container list /full=TRUE 0
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- --------
F: 0 Volume 10.0MB
Note that the example eliminates some items in the container
list display so that you can see an example of the RO column.
The following example changes array 0 from read-write status to
read-only status:
AAC0>container readonly 0
Executing: container readonly 0
5-72
Scsi
Usage C:ID:L RO
----
NTFS 0:02:0