Container Readwrite; Syntax; Parameters; Examples - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

container readwrite

To change an array's read-only status to read-write status, use the
container readwrite command. Subsequent modifications to
the data on the array are allowed. To use the container
readwrite command, none of the array's files can be open.

Syntax

container readwrite {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the array to make read-
write.

Examples

Before making an array read-write, use the container list
command (with the /full switch) to obtain information about any
existing arrays. As the following example shows, there is an array 0
(a volume set) on this controller. Note that the RO column displays
the value RO:
AAC0>container list /full
Executing: container list /full=TRUE
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- --------
F: 0 Volume 10.0MB
Note that the example eliminates some items in the container
list display so that you can see an example of the RO column.
The following example changes array 0 from read-only status to
read-write status:
AAC0>container readwrite 0
Executing: container readwrite 0
5-74
Scsi
Usage C:ID:L RO
----
NTFS 0:02:0 RO