Examples - Adaptec RAID 2120S Software Reference Manual

Examples

Before extending a volume set, use the container list
command to obtain information about any existing arrays. As the
following example shows, there is an array (volume set) 1 on this
controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
E: 1 Volume 100MB
Before extending the volume set, you might want to use the
command to display space usage information on the
show space
SCSI devices from which you plan to add freespace. The following
example extends a volume set by adding freespace from two SCSI
devices:
AAC0>container extend volume 1 ((2,0,0), 32M) ((2,1,0),
32M)
Executing: container extend volume 1
((CHANNEL=2,ID=0,LUN=0),33,554,432)((CHANNEL=2,ID=1,LUN
=0),33,554,432)
container 1 expanded.
As the command executes, note that the title bar of the DOS window
displays the status of the command. For example:
Stat:OK!,Task:101,Func:FSX Ctr:0,State:RUN 83.8%
See page 3-10 for detailed information on the status information that
the command displays in the title bar as it executes the task.
container Commands
Scsi Partition
Usage C:ID:L Offset:Size
NTFS 2:02:0 200MB: 100MB
disk
5-51