Enclosure Show Status; Syntax; Parameters; Examples - Adaptec RAID 2120S Software Reference Manual

enclosure show status

To display the general status of a specific SAF-TE enclosure
management device, use the enclosure show status
command. You can also use this command to display the general
status of all enclosure management devices connected to the
controller.
In addition to general status information, this command also
displays status information available from the following commands:
■
enclosure show fan
■
enclosure show power
■
enclosure show slot
■
enclosure show temperature

Syntax

enclosure show status [{enclosure}]

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device for which you want to display status information. For
this version, the controller supports a maximum of eight
enclosure management devices on each bus.
If you do not specify an ID, the command displays status
information for all enclosure management devices connected
to the controller.

Examples

The following example displays status information for enclosure
management devices 0 and 1:
AAC0>enclosure show status
Executing: enclosure show status
Enclosure UpTime D:H:M
--------- -------------- ---------- -------- -------- -------
0 0:04:25
PowerCycle Interval Door
2 20 UNLOCKED OFF
enclosure Commands
Alarm
11-37