Controller Reset_Scsi_Channel; Syntax; Examples - Adaptec RAID 2120S Software Reference Manual

controller reset_scsi_channel

To reset a specific SCSI channel, use the controller
reset_scsi_channel command.

Syntax

controller reset_scsi_channel
{integer}
Parameters
{integer}
Specifies the controller channel (for example, 0, 1, 2, 3, etc.) on
which you want to reset this SCSI channel. See the installation
guide for your controller to determine the number of channels
it actually supports.

Examples

The following example resets the SCSI channel on channel 1:
AAC0>controller reset_scsi_channel 1
Executing: controller reset_scsi_channel 1
controller Commands
6-17