Examples - Adaptec RAID 2120S Software Reference Manual

/wait{=boolean}
Specifies whether the command performs the scrub action
synchronously or asynchronously. If you set this switch to
TRUE, the command performs the scrub action synchronously,
which means the command prompt does not return until the
scrub action completes. If you set this switch to FALSE, the
command performs the scrub action asynchronously, which
means the command prompt returns immediately.

Examples

Before scrubbing a redundant array, use the
command to obtain information about any existing arrays. As the
following example shows, there is an array 0 (a mirror set) on this
controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
D: 0 Mirror 10.0MB
The following example synchronously scrubs array 0 using a delay
time of 5 milliseconds:
AAC0>container scrub /io_delay=5 /wait=TRUE 0
Executing: container scrub /io_delay=5
As the command executes, note the title bar of the DOS window
displays the status of the command. For example:
Stat:OK!Task:100,Func:MSC Ctr:0,State:RUN 97.2%
See page 3-10 for detailed information on the status information that
the command displays in the title bar as it executes the task.
container Commands
container list
Scsi Partition
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
0:02:0 10.0MB:
/wait=TRUE 0
10.0MB
10.0MB
5-95