Verify; Version - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide
This might take a few minutes.
Writing Adaptec 2200S (4MB) Flash Image to controller
0...OK. Verifying...OK
Please restart the computer to allow firmware changes to
take effect.

VERIFY

The VERIFY command compares the contents of each of the
flash components on a controller to the corresponding image
in a UFI file and indicates whether they match. Use this
command to determine whether a controller's flash
components are up-to-date when compared to a specific UFI
file.
Because the VERIFY command interrupts the controller's
normal operation, you must reset the controller upon
completion of this command.
Default Switch Values
If you do not include the /C switch, the AFU returns a fatal
error message.
If you do not include the /D switch, the AFU verifies against
UFI files in the current default drive and directory.
Example
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V4.0-0 B5749
(c)Adaptec Inc. 1999–2002. All Rights Reserved.
Reading flash image file (Build 5748)
Controller #0: Adaptec 2200S
ROM: Checksum: 797B [VALID]
File: Checksum: 797B [VALID]
Image Compares Correctly

VERSION

The VERSION command displays version information about
the flash components on a controller.
12-12
(Build 5748)
(Build 5748)