Switches; Examples - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide
{container}...
Specifies the ID (0 to 63) of one or more additional arrays from
which you want to create the multilevel volume set. You can
use up to 16 arrays. Typically, the additional arrays you
specify are the same type as the first array. For example, if the
first array is a stripe set then any subsequent arrays are also
stripe sets.

Switches

/label{=string}
Specifies a label to be assigned to the newly created multilevel
volume set. You can specify a maximum of sixteen characters
for the label.
If you do not specify the switch, it defaults to no label. If you
do not specify a label, you can do so later by using the
set label command.
container

Examples

Before creating a multilevel volume set, use the container list
command to obtain information about any existing arrays.
As the following example shows, there are two existing arrays
(stripe sets) on this controller at the time the multilevel volume set is
created:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Stripe 45MB
1 Stripe 15MB
5-20
Scsi Partition
Usage C:ID:L Offset:Size
64KB None 0:02:0 64.0KB:
0:03:0 64.0KB:
0:04:0 64.0KB:
64KB None 0:05:0 64.0KB:
15.0MB
15.0MB
15.0MB
15.0MB