Command And Switch Availability; Syntax; Parameters; Examples - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

Command And Switch Availability

This command and its associated switches (if any) are supported on
the following operating systems:
■
Windows NT
■ Windows 2000 (basic disk only)
■ Windows XP (basic disk only)

Syntax

container extend file_system {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the array whose file system
you want to extend.

Examples

Typically, you would use the container extend file_system
command after adding a level to an array and, perhaps, after
extending a multilevel volume set.
Before extending a file system, use the container list
command to obtain information about any existing arrays:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
E: 0 Volume 300MB
63 Volume 100MB
62 Volume 100MB
61 Volume 100MB
The following list describes the sequence that caused the previous
example to display:
1
Create a volume set of 100 MB on disk (1,0,0) with the
container create volume command.
2
Add a level to the volume set created in Step 1 with the
container add_level command.
5-44
Scsi Partition
Usage C:ID:L Offset:Size
NTFS
1:00:0 64.0KB:
1:01:0 64.0KB:
1:02:0 64.0KB:
100MB
100MB
100MB