Adaptec SCSI RAID Software Reference Guide
container remove failover
To remove one or more failover disks that were assigned to an array
using the container set failover command, use the
container remove failover command.
Syntax
container remove failover {container}
{scsi_device} [{scsi_device}...]
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose assigned
failover disk(s) you want to remove.
{scsi_device}
Specifies the ID for the SCSI device that you want to remove as
a failover disk for the array specified in the container
parameter. You previously assigned this SCSI device as a
failover disk with the
See the scsi_device section on page 3-7 for more
information on how to specify the SCSI device.
{scsi_device}...
Specifies the ID(s) for any other SCSI device(s) you want to
remove as failover disk(s) for the array specified in the
parameter.
container
5-86
container set failover
command.