Cli Command Syntax; Close; Exit; Parameters - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide
To enter subcommand mode, type the first part of any
command that has subcommands and press Enter. The
command you entered replaces the CLI> prompt and becomes
the first part of any subsequent command you enter.
For example, to use subcommand mode for the array
command:
1
Type array at the CLI> prompt, and press Enter.
The CLI> prompt changes to _array >.
2
Enter valid subcommands, switches, and parameters for
any array command and press Enter. For example, to
change the number of array 1 to 2, simply type the following
at the _array > prompt and press Enter:
move 1 2
To exit subcommand mode, press Enter. (You may have to
press Enter more than once to exit subcommand mode.)
■ CLI-unique commands
For NetWare systems, the following commands are unique to
the CLI in that you use these commands when accessing the
CLI from the NetWare server console:
– open

– close

– exit

– toggle_more
■ Comments—If the first non-blank character on a line in the
CLI is an exclamation point (!), the rest of the line will be
ignored. You can type comments after the exclamation point.
This is particularly useful in scripts where you want to
comment out sections of code.

CLI Command Syntax

You can enter only valid CLI software commands at the command
line prompt.
3-2