Examples - Adaptec RAID 2120S Software Reference Manual

/wait{=boolean}
Specifies whether the command performs the array
reconfiguration operation synchronously or asynchronously. If
you set this switch to TRUE, the command performs the array
reconfiguration operation synchronously, which means the
command prompt does not return until the array
reconfiguration operation completes. If you set this switch to
FALSE, the command performs the array reconfiguration
operation asynchronously, which means the command prompt
returns immediately.

Examples

Use the container list command to obtain information about
any existing arrays. As the following example shows, there is an
array 0 (a mirror set) and an array 1 (a volume set) on this controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Mirror 15.0MB
Tigris
E: 1 Volume 15.0MB
The following example reconfigures a volume set to a stripe set:
AAC0>container reconfigure /partition_size=1 /stripe 1
Executing: container reconfigure /partition_size=1
As the command executes, note that the title bar of the DOS window
displays the status of the command. For example:
Stat:OK!Task:100,Func:RCF Ctr:1,State:RUN 97.2%
See page 3-10 for detailed information on the status information that
the command displays in the title bar as it executes the task.
container Commands
Scsi Partition
Usage C:ID:L Offset:Size
None 1:02:0 64.0KB:
1:03:0 64.0KB:
NTFS 1:00:0 64.0KB:
/stripe=TRUE 1
15.0MB
15.0MB
15.0MB
5-81