Enclosure Set Scsiid; Notes; Syntax; Parameters - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

enclosure set scsiid

To set the SCSI device ID for a specific device slot on a specific SAF-
TE enclosure management device, use the enclosure set
scsiid command. As discussed in other chapters, a SCSI ID
consists of a SCSI channel number (for example, 0, 1, 2, 3, and so on),
SCSI device ID (0 through 15 inclusive), and SCSI device logical unit
number (0 through 7 inclusive). The enclosure set scsiid
command allows you to set the specified device slot to a specific
SCSI device ID (the middle number of a SCSI ID).

Notes

Before setting the SCSI device ID for a specific device slot on a
specific SAF-TE enclosure management device, use the
controller pause_io command. This command pauses all I/O
activity on the currently opened controller.
You cannot set the SCSI device ID for a specific device slot to a SCSI
device ID that is already in use. The command checks for SCSI
device ID conflicts and will display an appropriate error message if
you try to assign a SCSI device ID that is already in use.

Syntax

enclosure set scsiid {enclosure} {slot}
{device_id}

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device. The device slot to be assigned a SCSI channel number
is located on this enclosure management device. For this
version, the controller supports a maximum of eight enclosure
management devices on each bus.
{slot}
Specifies the unit number associated with the device slot that
you want to assign a SCSI channel number. This integer can
range from 0 to 15 inclusive.
11-22