Enclosure Set Door; Syntax; Parameters; Switches - Adaptec RAID 2120S Software Reference Manual

enclosure set door

To lock or unlock a specific door on a specific SAF-TE enclosure
management device, use the enclosure set door command.

Syntax

enclosure set door [/lock{=boolean}] {enclosure}
{door}

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to lock the door. For this version,
the controller supports a maximum of eight enclosure
management devices on each bus.
{door}
Specifies the unit number of the door for which you want to set
the lock. This number can range from 0 to 15 inclusive.

Switches

/lock{=boolean}
Specifies whether to lock the door associated with the specified
unit number. If you set this switch to TRUE, the command
locks the door associated with the specified unit number. If
you set this switch to FALSE, the command unlocks the door
associated with the specified unit number.
This switch defaults to FALSE.

Examples

The following example locks the door associated with unit 1 on
enclosure management device 0:
AAC0>enclosure set door /lock=TRUE 0 1
Executing: enclosure set door /lock=TRUE 0 1

Related Information

enclosure commands:
■
enclosure list
(page 11-7)
enclosure Commands
11-15