Controller Set Array_Verify; Syntax; Examples - Adaptec RAID 2120S Software Reference Manual

controller set array_verify

To enable or disable the array verify operation, use the
controller set verify command. This command allows you
to enable or disable the array verify operation for all arrays
controlled by the specified controller.

Syntax

controller set array_verify
[/verify_enabled{=boolean}]
/verify_enabled{=boolean}
Specifies whether to turn on or off the array verify feature on
the specified controller. You must set this switch to TRUE if
you want to turn on array verify for all arrays associated with
the specified controller.
To turn off the array verify feature on the specified controller,
set this switch to FALSE. The command defaults to TRUE,
which means the command turns on the array verify feature
on the specified controller.

Examples

Before turning the array verify feature on or off, check its status by
using the controller show array_verify command. The
following example shows that the controller's array verify feature is
currently off (disabled):
AAC0> controller show array_verify
Executing: controller show array_verify
Array verify DISABLED
The following example turns on (enables) the array verify feature for
the currently opened controller:
AAC0> controller set array_verify /verify_enabled
Executing: controller set array_verify /verify_enabled=TRUE
controller Commands
6-21