When To Replace - Segway Personal Transporter i2 Parts Replacement Manual

FASTENERS
Use only Segway-approved fasteners.
•
Do not tighten or reuse any fastener except the screws used to
•
attach the battery packs, wheel nuts, and LeanSteer frame.
Instead, when any other fastener is loose or removed, replace
the fastener with a new Segway-approved fastener. See
Appendix C, "Fasteners"
Before using a fastener, make certain the fastener is the
•
correct size and type with any necessary washer and thread
lock in place (see Table C-1
Since the pre-applied thread lock compound is intended for
•
single use only, reuse of fasteners is not permitted with the
exception of the wheel nuts, battery fasteners, and LeanSteer
clamp bolt.
Do not attempt to repair any stripped or damaged screw hole.
•
Instead, replace the part. If replacement part is not available,
do not reassemble.
Insert fasteners slowly and carefully. Do not cross-thread or
•
over-tighten fasteners. Tighten only to the prescribed torque.
Failure to adhere to these warnings could lead to serious injury
•
or death or damage to property.
ESD PROCEDURES
Any time repair involves opening the console or chassis cover, best-
practice electrostatic discharge (ESD) control procedures must be
followed. Failure to follow ESD procedures could result in personal
injury or damage to property.

When to Replace

When the brass insert is damaged, the entire
console must be replaced. See Figure 9‐2.
9‐2
for more information.
on page C-1).
Segway® Personal Transporter i2, x2, x2 Turf Parts Replacement