Standard Check; Operational Test - Segway Personal Transporter i2 Parts Replacement Manual

Standard Check

To perform a standard check, do the following:
1. Check that fasteners are in place, secure, and torqued correctly.
2. Check wheels for wear, tightness, and tire pressure.
3. Check that mats are intact, secure, and free of debris.
4. Check LeanSteer frame for tightness; make sure LeanSteer frame returns to center.
5. Check to make sure that no part is damaged or loose.

Operational Test

To perform an operational test, do the following:
1. Check for obstruction under mats.
2. Check LeanSteer frame for tightness and centered orientation.
3. Turn on and power off machine twice.
4. Confirm adequate battery levels.
5. Turn on machine to test rider detect. (Make sure that display does not indicate that rider
detect button is on at start‐up.) Tilt unit back and press on each rider detect button.
6. While holding machine platform level, tap mat with your foot to enter balance mode.
7. Step on and ride machine.
a. Move forward and backward.
b. Turn 360 degrees to the left and to the right.
A-2 Segway® Personal Transporter i2, x2, x2 Turf Parts Replacement