To Apply Power; To Operate The User Interface; To Clean The Logic Analyzer - Agilent Technologies 1670G Series Service Manual

To apply power

Check that the line voltage selector, located on the rear panel, is on the correct
1
setting and the correct fuse is installed.
See also, "To set the line voltage" on this page.
Connect the power cord to the instrument and to the power source.
2
This instrument is equipped with a three-wire power cable. When connected to an
appropriate ac power outlet, this cable grounds the instrument cabinet. The type of power
cable plug shipped with the instrument depends on the country of destination. Refer to
chapter 7, "Replaceable Parts," for option numbers of available power cables and plug
configurations.
Turn on the instrument power switch located on the front panel.
3

To operate the user interface

To select a field on the logic analyzer screen, use the arrow keys to highlight the
field, then press the Select key. For more information about the logic analyzer
interface, refer to the Agilent 1670G-Series Logic Analyzers User's Guide.
To set the GPIB address or to configure for RS-232-C, refer to the
Agilent 1670G-Series Logic Analyzer User's Guide.

To clean the logic analyzer

With the instrument turned off and unplugged, use mild soap and water to clean the
front and cabinet of the logic analyzer. Harsh soap might damage the water-base
paint.
Preparing for Use
To apply power
2–3