Table of Contents
Advertisement
Exit
Press Exit to return to the previous menu.
Laser
Press the Laser button to activate the laser pointer on the remote.
Select Inputs
You can use the IR remote to setup your inputs; however, Christie recommends that inputs
are setup through the WebUI.
An input is an input source physically connected to the projector. Input describes the source signal
to which it is connected. For a full explanation of how to connect sources to the projector, see
Connect a Source
on page 19.
1. From the Main menu, select Input & Switching.
2. From the Main Input drop-down menu specify the source of the image. Select from Input 1
and Input 2.
3. If the projector(s) will be operating with InfraScene, the source of the image for the secondary
input must be specified through the Secondary Input drop-down menu.
• To quickly and easily swap your inputs select Swap Main and Secondary Inputs.
• To adjust the gamma settings for the secondary input select Secondary Image Settings.
4. Frame Locking is enabled by default. This feature is used to select how the projector controls
the output frame timing based on the input signal. When set to Frame Lock, output image
frames are locked to the input if possible. When locked, the output is always locked to the main
input. When working with two inputs you can select input 2 as the lock source for the output by
selecting Frame Lock Secondary. See
ArrayLOC
Mirage WQ-L projectors use ArrayLOC to display a common gamut and brightness across an array of
projectors. ArrayLOC monitors the projector array and adjusts settings automatically. The following
section outlines how to manage color using ArrayLOC.
ArrayLOC is enabled by default.
Take Control of the Array
Use this menu to set up array color and brightness. By default ArrayLOC is configured to display the
EBU gamut at the maximum brightness the array can support.
1. On the projector you want to work with, access the ArrayLOC menu: Main Menu > ArrayLOC.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
See
Adjust Gamma Settings
on page 47.
Control Frame Locking
Operation
on page 48.
41
Advertisement
Table of Contents
