Table of Contents
Advertisement
Installation
This section explains how to install, connect and optimize the projector. Illustrations are graphical
representations only and are provided to enhance the understanding of the written material. When
designing a projection room for either a permanent or temporary installation, consider positioning
the projector and screen for maximum audience coverage and space efficiency. For example,
placing the screen along the larger wall in a rectangular room reduces audience coverage.
Other considerations:
•
Operating single or multiple units.
•
Room size.
•
Lighting and audience seating.
•
Distance between the audience and the display.
•
Angle from which the display is viewed.
Installation Procedures
Unpack the Projector
The projector should be lifted by two people. Use the designated handles to help lift and
support the projector. Use a stable cart to transport the projector. Failure to comply could
result in minor or moderate injury.
Do not place the projector onto a surface with the line cord retainer side down. Failure to
comply may result in damage to the line cord retainer.
Christie recommends that the packaging material for at least one projector is saved in case
one needs to be shipped for service.
The projector is shipped assembled with the projection lens shipped separately. Install the lens
once the projector is fully assembled and in its final position. See
1. Remove the line cord from the packaging.
2. Remove the top foam from the box.
3. Open the bag and lift the projector up using the two handles. It is recommended that two
people remove the projector, each holding onto a handle.
4. Rotate the projector 90° and place on a flat surface.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Install the Lens on page
16.
13
Advertisement
Table of Contents
