Table of Contents
Advertisement
SDI video source connection from an Integrated Media Block
(IMB)
The projector can accept digital video data from SDI sources connected to applicable Integrated Media
Block (IMB) devices.
The input configurations supported are determined by the IMB device directly. Contact Christie
Technical Support to learn which IMB devices provide SDI source selection from the projector user
interface.
SDI input selection directly from the IMB may also be possible using the IMB user interface. The input
configurations supported are determined by the IMB make and model.
GPIO connector
The Generic Purpose Input Output (GPIO) connectors provide a flexible method of interfacing with the
projector. There are three GPIO connectors with one connector reserved for serial communications.
The GPIO connectors are located on the input panel (E in the Video Input panel image (on page 28)).
Left-side GPI pins
The top six GPI pins are available for inputs with the other two pins reserved for ground and power.
The bottom pins are reserved for serial communications.
Pin number
Signal name
T1
+5V
Cinema 2K-RBe Installation and Setup Guide–CP2406-RBe, CP2409-RBe, and CP2411-RBe
020-103907-01 Rev. 1 (03-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Direction
—
Video Input panel
36
Advertisement
Table of Contents
