Sequence Function; Sequence - Seqload (Load Sequence(S)) - Yamaha A3000 Owner's Manual

SEQUENCE Function

SEQUENCE - SeqLoad (Load Sequence(s))

Loads one or all sequences from disk.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knobs 2, 3
Chapter 7 DISK Mode
264
SEQUENCE Function
You use the SEQUENCE function to load one or all sequences from a floppy disk or SCSI
disk volume into the A3000 main memory. Before using this function, you must select
the source disk or volume using the DISK or VOLUME function.
• If loading from a floppy disk, you must first insert the floppy disk into the A3000
floppy drive, and then select the disk at the DISK function. ( 268)
• If loading from a SCSI disk, you must first select the disk (partition) and volume
containing the sequence(s) you want to load. ( 268, 266)
For details about the relationship between disks, partitions, and volumes, refer to the
section entitled "Disks and Volumes" in Chapter 3. ( 81)
FYI
Before you can load sequences, you must first save them to disk. You can save your
sequence(s) to disk using the UTILITY | SEQUENCE function. ( 281)
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
-
Use this page to load one or all sequences from disk.
Push the knob to move to the Program/Sample Selection screen. ( 95)
Sequence
If you want to load a single sequence from disk, turn this knob to select the disk-side
sequence.
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= sequence name
Knob 4 Knob 5
- -
Select P/S