Yamaha A3000 Owner's Manual page 44

Starting Out
Playback
Chapter 2 Trying It Out
42
We will now proceed to play the sample that we have just recorded.
Procedure
Select PLAY mode, and then select the PROGRAM function.
1.
PLAY
PROGRAM
EDIT
TRIM / LOOP
RECORD
REC
PROGRAM
DISK
TOTAL EQ
UTILITY
The screen looks like this.
Although it is possible to play samples when working at other pages, in most cases you
want to use this page to start the replay.
2. Strike a key on your MIDI keyboard.
Striking the key should cause your sample to play back. If you did not hear anything,
check the speaker and MIDI connections. You may also need to adjust the MASTER VOL
on the A3000 (the far left dial on the front panel), or the output level on your speakers.
Memo
Notice that you play a program, rather than a specific sample. In this case, you are playing program
Pgm001, which is set up to play the sample that you just recorded (_NewSample).
• If you are not happy with the recording results, turn to the next page for information
about how to delete the sample so that you can record it again. If you are pleased with
the result, you are ready to proceed to the "Next Step" section, starting on page 45.
• If you wish to stop for a while and switch off the power, note that your recorded
sample will be lost unless you first save it to disk. You can save the sample by insert-
ing a formatted floppy disk into the drive, then proceeding as described on pages 64 to
66. When you are ready to resume operation, please reload the data from the disk
( 67) and then proceed to the "Next Step" section ( 45).
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
CONTROL
MIDI / CTRL
MONITOR
IMPORT
MIDI