Midi Function; Midi - Receive - Yamaha A3000 Owner's Manual

Use this function to set the various MIDI parameters.

MIDI - Receive

Sets the MIDI reception parameters.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
This page sets the A3000's MIDI reception parameters.
Knob 1 Change Page
• Turn the knob to change to a different page within the MIDI function. Available pages
• Push the knob to move to the Program/Sample Selection screen. ( 95)
BasicCh
Knob 2
• This value sets the A3000's "Basic Receive" channel.
• If Omni=on (see explanation for Knob 4 below), then the BasicCh setting is mean-
• Playback messages (Note messages) on this channel control playback of all samples
• Control-change messages on this channel control playback of programs, in accord-
• Program-change messages on this channel cause the A3000 to change programs (pro-
• If you wish to set the channel from an external MIDI device, push the knob so that

MIDI Function

EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
are: Receive (this page), Adjust, RcvFlt, and Bulk.
= 1,...,16
ingless — since the A3000 accepts messages over all channels. If Omni=off, then the
BasicCh sets the channel used to receive control-change and program-change mes-
sages, and the default channel for playback (Note-On and Note-Off) messages.
whose ReceiveCh setting is set to Bch. ( 209)
ance with each program's controller setup. ( 135)
vided that PgmChange is set on; see explanation for Knob 4 below).
the knob indicator begins blinking. Then transmit any channel message from the
MIDI device; the A3000 will detect the channel and display the value over the knob.
Lock in the setting in pushing the knob again or by changing to a different page.
MIDI Function
Turn Knob 1 to select Receive.
Knob 3 Knob 4
- -
Select P/S
MIDI IN
Chapter 8
Knob 5
-
-
UTILITY Mode
305