(2)
Repeat this step for each SIMM that you wish to install.
* If you need to remove a SIMM from a socket, hold open the two hooks on the socket
(one at each end) and push on the SIMM so that it moves to the opposite angle from
that shown in Figure (2) (toward yourself in the diagram), and then pull the SIMM
out.
This completes the installation. There is no need to remove the expansion board when
installing other devices.
Return the top cover to its original position, and fasten into place with the
6.
screws removed at Step 3 above.
• When remounting the cover, be careful to keep clear of internal cabling, and do not
allow cables to be pinched or pulled.
• When refastening the three screws on the top, press inward on the top center part of
the front panel.
Plug in the power cord.
7.
• The UTILITY - SYSTEM FreeMem page allows you to verify that the installed SIMM
modules were detected correctly. ( 304)
Installing SIMMs
Appendix
315