Midi/Ctrl - Smpctl1 (Sample Controller Setup 1) - Yamaha A3000 Owner's Manual

MIDI/CTRL Function

MIDI/CTRL - SmpCtl1 (Sample Controller Setup 1)

Sets up the sample's controller usage.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Chapter 5 EDIT Mode
210
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
You use this page together with page SmpCtl2 to set up the controller matrix that
determines how selected MIDI controllers operate on the sample's playback. The matrix
selects up to six controllers, and assigns to each of these a specific function and operat-
ing range. A conceptual illustration of the matrix is shown below.
Selects a controller.
Matrix No
Matrix#
1
2
3
4
5
6
You use the SmpCtl1 page to set the Device and Function values only. Use page SmpCtl2
( 213) to set the Type and Range values.
Change Page
• Turn the knob to change to a different page within the MIDI/CTRL function. Avail-
able pages are: RCh&Alt, SmpCtl1 (this page), SmpCtl2, and Vel&PB.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
CONTROL
MIDI / CTRL
Turn Knob 1 to select SmpCtl1.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
-
Determines how the A3000 converts
the received controller values.
Selects the controlled parameter.
Device Function
Knob 4 Knob 5
- -
Sets the maximum control range.
Type Range
Select P/S