Effect Function; Effect - Eftype (Select The Effect Types) - Yamaha A3000 Owner's Manual

EFFECT Function

EFFECT - EfType (Select the Effect Types)

Selects effect types and sets effect use on or off.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 5
Chapter 6 RECORDING Mode
238
EFFECT Function
The EFFECT function sets the recording effect(s). If the recording-effect switch is ena-
bled, the A3000 passes the incoming signal through the selected effect(s) before record-
ing it into memory.
Most of the settings provided here are identical to those that you use to set up the
program effects. The explanations below describe only those parameters that are differ-
ent. For detailed information, refer to the explanations for the PLAY | EFFECT function.
( 121)
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
• With the exception of the Knob 5 setting, this page is identical to the corresponding
PLAY| EFFECT page ( 121). Knob 5, however, sets the recording-effect switch rather
than the effect-block interconnection.
• Note that the A3000 always uses a "1 2 3 " connection type when applying re-
cording effects. The incoming signal passes through Effect 1 first, then through Ef-
fect 2, and then through Effect 3.
• For information about the available effect types, refer to the "Effect type list" in the
Appendix. ( 335)
RecEfSW
• This setting determines whether the A3000 passes the incoming signal through the
effect blocks before recording it. If you set the value to off, the signal does not receive
any effect. If you set the value to 1 2 3 , the signal passes sequentially through
all three blocks.
• Note that this setting is forced to off if the Input setting ( 227) is set to STOut,
DIGITAL, or OPTICAL.
CONTROL
MIDI / CTRL
Turn Knob 1 to select EfType.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
= off, 1 2 3
Knob 4 Knob 5
-