Setup - Target - Yamaha A3000 Owner's Manual

SETUP Function

SETUP - Target

Selects the recording method, sets the sample name, and assigns the sample to a program.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Chapter 6 RECORDING Mode
230
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to select the recording method (replacement, new, or serial), set the sam-
ple name, and assign the sample to a program.
Change Page
• Turn the knob to change to a different page within the SETUP function. Available
pages are: RecData, Target (this page), KeyRnge, Trigger, and Process.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Sample
This setting selects the recording method.
Replace
New
New+
• Note that Replace is not available if you have selected a sample bank rather than a
sample.
CONTROL
MIDI / CTRL
Turn Knob 1 to select Target.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
-
-
= Replace, New, New+
Record the new sound directly into the currently selected sam-
ple, overwriting (completely replacing) its waveform data. But
retain all of the existing sample's parameter settings (key range,
original key, etc.).
Record a new sample.
Record a series of new samples.
Knob 4 Knob 5
-
-
Select P/S