Trim/Loop - Wave (Edit Waveform) - Yamaha A3000 Owner's Manual

TRIM/LOOP Function

TRIM/LOOP - Wave (Edit Waveform)

Sets start and end addresses, and "trims" the waveform.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Chapter 5 EDIT Mode
164
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to select the playback start and end points on the waveform. You can also
use it to delete the unused area at each end of the waveform so as to free up additional
memory.
FYI
You can use the EndType setting on the Configure page to select the method for display-
ing the end address. ( 161)
Change Page
• Turn the knob to change to a different page within the TRIM/LOOP function. Avail-
able pages are: Config, Wave (this page), Loop, and WvMode.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Start
• Sets the playback "start" address on the waveform. (Note that the waveform itself
always starts at address 0.) The concept is illustrated below.
• Note that the actual playback start location is also determined by the settings that
you make at the Wave Mode page ( 168).
• If you push this knob while playing the sample with the AUDITION key or an external
keyboard, the start address automatically resets to the current playback location.
CONTROL
MIDI / CTRL
Turn Knob 1 to select Wave.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
= 0, ..., end address
Start Address
Playback Area of Waveform
Knob 4 Knob 5
-
Select P/S
Realtime Set
End Address