Control - Pgmctl2 (Program Controller Setup 2) - Yamaha A3000 Owner's Manual

Yamaha professional sampler owner's manual a3000
Hide thumbs Also See for A3000:
Table of Contents

Advertisement

CONTROL - PgmCtl2 (Program Controller Setup 2)

Sets the program's controller usage.
PLAY
PROGRAM
SAMPLE
EASY EDIT
EDIT
TRIM / LOOP
MAP / OUT
FILTER
REC
RECORD
SETUP
METER
DISK
PROGRAM
SAMPLE
SEQUENCE
UTILITY
TOTAL EQ
PANEL PLAY
SEQUENCE
Turn action
Push action
You use this page together with page PgmCtl1 to set up the program's controller matrix.
The matrix determines how selected MIDI controllers operate on the program's play-
back.
You use PgmCtl1 to set each matrix entry's Device and Function. You use this page
(PgmCtl2) so set each entry's Type and Range.
Refer to the explanation of PgmCtl1 ( 135) for a conceptual illustration of the matrix.
Knob 1
Change Page
• Turn the knob to change to a different page within the CONTROL function. Available
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Matrix#
Knob 2
Selects the matrix entry for editing. You can use the matrix to set up four controllers.
Each matrix entry sets up a different controller.
Type
Knob 3
The setting determines how the A3000 converts and applies the control-change value
received from the controller.
When you move a controller at a MIDI device, the controller transmits a control-change
value indicating the magnitude of the movement. The transmitted values always range
from 0 to 127.
Upon receiving the value, the A3000 converts it as specified here, and then applies it to
the parameter selected by the Function entry ( 138). The conversion determines how
strongly (and in which direction) the parameter changes in response to the controller's
movement.
Note that the conversion also depends on the "range" value, which you set using Knob
4 (see below).
EFFECT
SETUP
CONTROL
EG
LFO
MIDI / CTRL
EFFECT
EXT CTRL
MONITOR
VOLUME
DISK
IMPORT
MASTER
SYSTEM
MIDI
Knob 1
Knob 2
-
pages are: PgmCtl1, PgmCtl2 (this page), and Reset.
= 1,...,4
= +offset, -/+offset
CONTROL Function
Turn Knob 1 to select PgmCtl2.
Knob 3
Knob 4
-
-
Select P/S
Chapter 4
Knob 5
-
-
PLAY Mode
139

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents