Disk Function; Disk - Disk - Yamaha A3000 Owner's Manual

DISK Function

DISK - Disk

Selects a disk (partition).
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Chapter 7 DISK Mode
268
DISK Function
You use the DISK function to select and manage disks (partitions). The A3000 uses the
disk that you select as the source for data loads. This selection also determines the
volumes that you can select at the VOLUME function ( 266).
You can also use this function to change the SCSI ID of the A3000, and to enable or
disable use of connected SCSI disks and CD-ROM drives.
Finally, you use this function's command pages to format your disks (both hard disks
and floppies), and to create and manage disk partitions. You access the command pages
by selecting the DISK function, then pressing the COMMAND key ( 252 to 258).
For details about the relationship between disks, partitions, and volumes, refer to the
section entitled "Disks and Volumes" in Chapter 3. ( 81)
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
• Use this page to select the disk (partition) used for data loads, and to change the disk
(partition) name.
• The right side of the screen indicates the amount of free space on the currently se-
lected disk (partition).
FYI
If you find that you are unable to access a connected SCSI disk or CD-ROM, go to the
Configure page ( 270) to check the device's SCSI ID and to make sure the device is
enabled ("mounted").
CONTROL
MIDI / CTRL
Turn Knob 1 to select Disk.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3 Knob 4 Knob 5
- -
- -