Control Function; Control - Pgmctl1 (Program Controller Setup 1) - Yamaha A3000 Owner's Manual

CONTROL Function

CONTROL - PgmCtl1 (Program Controller Setup 1)

Sets the program's controller usage.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Chapter 4 PLAY Mode
136
CONTROL Function
The PLAY-mode CONTROL function sets up the program's controller handling.
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
You use this page together with page PgmCtl2 to set up the controller matrix that
determines how selected MIDI controllers operate on the program's playback. The ma-
trix selects up to four controllers, and assigns to each of these a specific function and
operating range. A conceptual illustration of the matrix is shown below.
The controller settings that you make here operate in response to control-change mes-
sages received over the Basic Receive Channel. ( 305)
Selects a controller.
Matrix No.
Matrix#
1
2
3
4
You use the PgmCtl1 page to set the Device and Function values only. Use page PgmCtl2
( 139) to set the Type and Range values.
CONTROL
MIDI / CTRL
Turn Knob 1 to select PgmCtl1.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
-
Determines how the A3000 converts
the received controller values.
Selects the controlled
parameter.
Device Function
Knob 4 Knob 5
- -
Sets the maximum
control range.
Type Range