Eg - Feglevel (Filter-Eg Levels) - Yamaha A3000 Owner's Manual

EG Function

EG - FEGLevel (Filter-EG Levels)

Sets the levels for the filter EG.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Chapter 5 EDIT Mode
194
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page together with the FEGRate page ( 192) to set up the sample's FEG (filter
envelope generator). The FEG determines how the filter's cutoff frequency shifts over
time as each note plays out.
The FEGLevel page (this page) sets the FEG's levels (initial, attack, sustain, and release).
The FEGRate page sets the FEG's various rates (attack, decay, and release rates).
Important
• It is not possible to set the actual cutoff frequency beyond a certain range. Regardless
of settings you make at this page, the cutoff frequency will not shift beyond these
limits.
• Filter-EG settings are not effective if the Type parameter on the Filter page ( 182) is
set to Bypass.
Change Page
• Turn the knob to change to a different page within the EG function. Available pages
are: AEG, AEGMode, FEGRate, FEGLevel (this page), FEGMode, PEGRate, PEGLevel,
and PEGMode.
• Push the knob to move to the Program/Sample selection screen. ( 95)
Init
This value sets the initial level (the cutoff-frequency offset applied at time of Note On).
CONTROL
MIDI / CTRL
Turn Knob 1 to select FEGLevel.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= -127,...,+127
Knob 4 Knob 5
- -
Select P/S