Midi/Ctrl Function; Midi/Ctrl - Rch&Alt - Yamaha A3000 Owner's Manual

MIDI/CTRL Function

MIDI/CTRL - RCh&Alt (Receive Channel and Alternate
Sets the sample's MIDI Receive Channel and "alternate group."
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Chapter 5 EDIT Mode
208
MIDI/CTRL Function
You use the MIDI/CTRL function to set the sample's MIDI Receive Channel, to designate
its "alternate group," and to set up its controller handling.
FYI
The COMMAND key gives you rapid access to a number of helpful commands while you
are working with this function. For example, you can use the COMMAND key when you
want to save your edit results to disk, or when you want to cancel your new changes and
restore the previously saved data. ( 147)
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
You use this page to set the sample's MIDI Receive Channel, and to assign the sample to
an "alternate group."
Important
If you set the sample into an alternate group (if you set the AlternateGroup parameter to
any value other than "off"), you will not be able to play more than one note at a time
from the sample, since each new note from the sample automatically switches off any
preceding note from the sample.
Change Page
• Turn the knob to change to a different page within the MIDI/CTRL function. Avail-
able pages are: RCh&Alt (this page), SmpCtl1, SmpCtl2, and Vel&PB.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
CONTROL
MIDI / CTRL
Turn Knob 1 to select RCh&Alt.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
-
-
Knob 4 Knob 5
-
- -
Select P/S