Command Pages; Load - Yamaha A3000 Owner's Manual

This section describes the command screens (command pages) that you can access by pressing
the COMMAND key while working in DISK mode.

LOAD

Loads the selected disk-resident program into any program number in memory.
PLAY PROGRAM SAMPLE
EDIT TRIM / LOOP MAP / OUT
REC RECORD SETUP
DISK PROGRAM SAMPLE
UTILITY TOTAL EQ PANEL PLAY
Turn action
Push action
Knob 1
Knobs 3, 4 Program

COMMAND Pages

EASY EDIT EFFECT SETUP CONTROL
FILTER EG LFO MIDI / CTRL
METER EFFECT EXT CTRL MONITOR
SEQUENCE VOLUME DISK IMPORT
SEQUENCE MASTER SYSTEM MIDI
Knob 1 Knob 2
- -
-
Use this command when you want to load the selected disk-resident program into main
memory under a different program number. You can load the program into any pro-
gram number (001 to 128) on the memory side. The number at the disk side remains
unchanged.
Push the knob when you are ready to execute the load. The A3000 returns a confirma-
tion screen. Push Knob 5 (>YES) to proceed with the load, or Knob 4 (>NO) to cancel.
= 001,...,128
Turn either knob to select the destination program number (memory-side program
number). The bottom line of the screen displays the destination number.
Press the COMMAND key.
Knob 3 Knob 4
- -
>LOAD
Chapter 7
DISK Mode
Knob 5
-
-
DISK Mode
249