Yamaha A3000 Owner's Manual page 185

Yamaha professional sampler owner's manual a3000
Hide thumbs Also See for A3000:
Table of Contents

Advertisement

LowPass2
HiPass1
HiPass2
BandPass
BandElim
Low Pass
Level
Band Pass
Level
Cutoff
Knob 3
Use this knob to set the filter's cutoff frequency.
FltGain
Knob 4
• Use this knob to set the filter's output level.
• Note that high settings may produce distortion when used with certain sample sounds
or when many samples are played together.
Q/Width
Knob 5
This knob sets the Q value (resonance) or width setting, depending on the filter type.
• If you select a low-pass or high-pass filter, this setting selects the Q value. The Q value
determines the amount of emphasis applied to frequencies that are very close the
cutoff point. (See drawing above.) Higher settings produce stronger emphasis. Note
that high settings for a LowPass2 or HiPass2 filter may produce distortion with cer-
tain samples.
• If you select the band-pass filter, this setting determines the width of the band that is
allowed to pass. Increasing the setting will widen the band, allowing more frequen-
cies to pass.
• If you select the band-eliminate filter, this setting determines the width of the fre-
quency ranges that are allowed to pass. Increasing the setting will allow more fre-
quencies to pass (will reduce the elimination zone). Note that the elimination band
itself becomes narrower as you increase the value.
Low-pass filter #2. Offers much higher Q (resonance) than low-
pass filter #1.
High-pass filter #1. (A high-pass filter blocks out all frequen-
cies below the cutoff frequency.)
High-pass filter #2. Offers much higher Q (resonance) than high-
pass filter #1.
Band-pass filter. (Allows only frequencies near the cutoff fre-
quency to pass; blocks out all higher and lower frequencies.)
Band-eliminate filter. (Blocks out the frequency range around
the cutoff frequency, while allowing higher and lower frequen-
cies to pass.)
Q emphasis
These frequencies
These frequencies
pass.
are cut.
Frequency
Cutoff
These frequencies pass.
These frequencies
These frequencies
are cut.
are cut.
Frequency
Cutoff
= 0,...,127
= -31,...,+31
= 0,...,31
FILTER Function
High Pass
Q emphasis
Level
These frequencies
These frequencies
are cut.
pass.
Cutoff
Band-Eliminate
These frequencies are cut.
Level
These frequencies
These frequencies
pass.
pass.
Cutoff
Chapter 5
Frequency
Frequency
EDIT Mode
183

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents